Cutting Operation; Optional Accessories - Makita DJS200 Manual De Instrucciones

Installing cutting head
CAUTION:
Secure the cutting head firmly.
Otherwise the cutting head may rotate during opera-
tion and cause serious injury.
Insert the cutting head into the tool by turning it left and
right alternately. Then tighten the three bolts in the order
of A, B, C with the hex wrench (5/32").
Make sure the bolts are fastened with 5.1 - 5.7 N•m (45
- 50 in•lbs) before using the tool.
► Fig.8: 1. Cutting head 2. Bolt 3. Hex wrench (5/32")
4. Tighten
Hook
CAUTION:
Never hook the tool at high loca-
tion or on potentially unstable surface.
► Fig.9: 1. Groove 2. Hook 3. Screw
The hook is convenient for temporarily hanging the tool.
This can be installed on either side of the tool.
To install the hook, insert it into a groove in the tool
housing on either side and then secure it with a screw.
To remove, loosen the screw and then take it out.
OPERATION
Adjusting shear blade
Adjust the side blade L to prevent the curl of the workpiece
from contacting the cutting head and the workpiece.
Loosen bolts with the hex wrench (5/32"). Move the
side blade L back and forth to adjust it. Then tighten the
three bolts with the hex wrench (5/32").
► Fig.10: 1. Bolt 2. Side blade L
Lubrication
NOTICE:
Use the standard machine oil for steel
or the mineral spirits for aluminum.
Before operation, always lubricate the following areas:
A The cutting area of the workpiece.
B The part of the center blade which contacts to the
workpiece.
C The both sides of the center blade which contacts
to the side blade L and side blade R.
► Fig.11
Adjusting cutting head angle
CAUTION:
Make sure the cutting head is
secured in the position after adjusting the cutting
head angle. Otherwise the cutting head may rotate
during operation and cause serious injury.
Rotate the cutting head while pushing the rotation
button.
Release the rotation button when the cutting head is in
the desired angle.
► Fig.12: 1. Rotation button

Cutting operation

CAUTION:
Wear gloves. Edges and chips of the
workpiece are sharp and may cause injury.
Secure the workpiece firmly. Move the tool forward
keeping the side blades flush with the workpiece
surface.
► Fig.13: 1. Side blade 2. Workpiece
MAINTENANCE
CAUTION:
Always be sure that the tool is
switched off and the battery cartridge is removed
before attempting to perform inspection or
maintenance.
NOTICE:
Never use gasoline, benzine, thinner,
alcohol or the like. Discoloration, deformation or
cracks may result.
To maintain product SAFETY and RELIABILITY,
repairs, any other maintenance or adjustment should
be performed by Makita Authorized or Factory Service
Centers, always using Makita replacement parts.
OPTIONAL
ACCESSORIES
CAUTION:
These accessories or attachments
are recommended for use with your Makita tool
specified in this manual. The use of any other
accessories or attachments might present a risk of
injury to persons. Only use accessory or attachment
for its stated purpose.
If you need any assistance for more details regard-
ing these accessories, ask your local Makita Service
Center.
• Hex wrench (5/32")
• Makita genuine battery and charger
NOTE: Some items in the list may be included in the
tool package as standard accessories. They may
differ from country to country.
8 ENGLISH