Operation; Tighten Cover On The Polishing Disc; Switching On And Off; Waxing/Polishing Paint Surfaces - ULTIMATE SPEED UPM 120 B1 Traducción Del Manual De Instrucciones Original

b) Ear damage if working without ear
protection.
c) Eye damage if no suitable eye protec-
tion is worn.
d) Damage to your health caused by
swinging your hands and arms when
operating the appliance for longer pe-
riods of time or if the unit is not held or
maintained properly.
Warning! During operation, this
electric tool generates an electro-
magnetic ield which, under certain
circumstances, may impair the
functionality of active or passive
medical implants. To reduce the risk
of serious or lethal injuries, we rec-
ommend that persons with medical
implants consult their doctor and
the manufacturer of their medical
implant before operating the ma-
chine.

Operation

Caution! Risk of injury!
- Always remove the mains plug
before working on the tool.
The mains cable is to run over the
user's shoulder during the use of the
polishing machine to avoid contact
with the polished surface. This is to
prevent scratches from the mains
cable.
Tighten cover on the
polishing disc
1. Align the polishing disc (3) upwards.
2. Using both hands, grab hold of a
towelling cover (5) or a synthetic fur
cover (4) and expand the elastic band
outwards.
3. Put the cover (4/5) on a part of the
polishing disc (3) over the edge of the
polishing disc. Pull the cover around
the edge.
4. Fit the cover (4/5) in centrally and
tightly around the polishing disc (3).

Switching on and off

Make sure that the power supply
voltage matches the voltage rating
indicated on the device's type
plate.
Connect the machine to the power
supply.
1. To switch on, tilt the on/off switch (2)
to position „I", the device turns on.
2. To switch off, tilt the on/off switch (2)
to position „0", the device turns off.
3. Firmly hold the device with both hands
on the handle (1).
Waxing/polishing paint
surfaces
1. Use the towelling cover (5) to apply
polish.
2. Apply the wax or polish on a slightly
smaller area than the area you would
like to polish.
3. Work with the polish in a crosswise
movement or circular motions. Exert
only moderate pressure on the surface.
4. Please refer to the information from the
polish manufacturer.
Do not allow the polish to dry out.
There is a risk or surface damage.
Therefore, do not work in direct sun-
light or on a heated surface.
GB MT
41