Dewaxing/Polishing Paint Surfaces; Cleaning And Maintenance; Cleaning; Storage - ULTIMATE SPEED UPM 120 B1 Traducción Del Manual De Instrucciones Original

GB MT
Dewaxing/polishing paint
surfaces
1. Use the synthetic fur cover (4) for
dewaxing purposes.
2. Work in a crosswise movement or
circular motions. Exert only moderate
pressure on the surface.
3. Please refer to the information from the
polish manufacturer.
Cleaning and
maintenance
Pull the mains plug before any ad-
justments, maintenance or repair.
Have any work on the device
that is not described in this
instruction guide performed
by a professional. Only use
original parts. Allow the de-
vice to cool off before any
maintenance or cleaning is
undertaken. There is a risk of
burning!
Always check the device before using it for
obvious deiciencies such as loose, worn
or damaged parts, correct the position-
ing of screws or other parts. Examine the
polishing disc in particular. Exchange the
damaged parts.
42

Cleaning

Do not use any cleaning agent or
solvent. Chemical substances can
etch the plastic parts of the device.
Never clean the device under run-
ning water.
• Thoroughly clean the device after
every use.
• Clean the ventilation openings and the
surface of the device with a soft brush
or cloth.
• Hand wash to thoroughly clean the
covers after each use. Only use a mild
soap sud.

Storage

• Store the appliance in a dry place (0-
40°C) well out of reach of children.
Waste disposal
and environmental
protection
Be environmentally friendly. Return the
tool, accessories and packaging to a recy-
cling centre when you have inished with
them.
Electrical machines do not belong
with domestic waste.
• Hand over the device at an utilization
location. The plastic and metal parts
employed can be separated out and
thus recycled use can be implemented.
Ask our Service-Center for details.
• Defective units returned to us will be
disposed of for free.