BADU EasyFit Eco VS Ficha Técnica página 25

WG27.50.007-P
WG27.50.008-P
Notice: The speed cannot be changed during the priming
phase.
11|2016
Operation:
Press the button "1", "2" or "3" to
select the preset fixed speed.
If the pump starts from a standstill, it
starts up in priming mode (in far as it
is activated) and subsequently with
the selected fixed speed.
As long as the pump is in the priming
phase a bar moves in the first
position on the display from the
lower, through the middle to the
upper position.
During operation the pump is started
up to the fixed speed directly, without
priming time.
The motor is stopped by pressing the
"0" button. The "Power" LED flashes
and the display shows "oFF".
Setting the speeds:
Press the button of the fixed speed
that is to be changed ("1", "2" or
"3") and then change the speed by
using the "▼ ▲" buttons. The set
speed is stored directly and
approached immediately when the
fixed speed is selected again.
EN 25