Atsumi Electric Tri Watcher SIR10SA Manual De Instalación página 6

7
Remove Lens 1, 1' and affix masking tape to the
inside of Lens 1, 1'.
 The masking locations are "H" to "P" on Lens 1, 1'.
A B C D E F
G
H I J K L M N
P
O
Lens 1
confi guration
A B C D
H I J K L M N
O
Lens 1' confi guration
Lens 1
Lens 1'
CAUTION
The shape of the projections on lens 1, 1' and lens 2
are different. When mounting the lens, be careful not
to mistake them. This could cause a malfunction or
breakdown.
After the lens is removed, do not touch the main
device internal parts. This could cause a malfunction or
breakdown.
8
Mount the front cover.
Cover
b c d e f
a
g
k
j l
m
i
n
h
o
Lens 2 confi guration
E F
G
P
Lens 2
9
Rotate the main device by 180 degrees, and tighten
the six cover screws.
10
Set back the small cover, and tighten the two screws.
* The small cover can be mounted in either direction.
Small cover
11
Rotate the main device, align the alarm direction,
and then tighten the lower cover screws to secure in
place.
Main device
Rotation is possible 180
degrees in the left
direction.
6
Rotation is possible
135 degrees in the
right direction.