Kitchen Aid KSM8990 Manual De Usuario página 7

PRODUCT ASSEMBLY
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death, fire, or
electrical shock.
5
Test the beater to bowl clearance: Plug
the Stand Mixer into a grounded 3 prong
outlet. Turn Stand Mixer ON and test
each speed, making sure the beater does
not touch the bowl during operation.
If the beater is too far away from the
bottom or is hitting the bowl, proceed to
next step to make adjustments.
IMPORTANT: When properly adjusted, the flat beater will not strike on the bottom or
sides of the bowl. If the flat beater or the wire whip is so close that it strikes the bottom
of the bowl, coating may wear off the beater or wires on the whip may wear.
W11378207C.indb 7
WARNING
Electrical Shock Hazard
6
Raise Bowl
(OPTIONAL) To adjust beater to
bowl clearance: Lower the bowl to the
down position. Turn the screw slightly
counterclockwise (left) to raise the beater,
or clockwise (right) to lower it. Adjust the
beater so that it just clears the surface of
the bowl. Check again the clearance of
the beater to the bowl.
Lower Bowl
7
11/25/2019 7:50:17 AM