Smeg MFF01 Manual Del Usuario página 12

What To Do If......
Problem
The appliance does not
work.
The appliance stops dur-
ing operation.
The cycle does not start.
The milk fails to froth.
The ingredients do not
dissolve.
Contact local technical support if the problem is not solved or in case of other types
of faults.
12 - EN
What To Do If.....
Possible causes
Plug not connected.
The jug is empty.
The jug was removed dur-
ing preparation.
Ingredients too thick or too
large like large chocolate
chips.
The jug has not been fitted. Place the jug in the appropri-
The whisk has not been
fitted.
Milk is not cold.
The jug contains residual
water or is dirty.
The whisk used is not cor-
rect.
Use of already frothed or
heated milk.
Use of low-fat milk.
The ingredients are
too thick or
too much.
Solution
Connect the plug.
Fill the jug.
Reposition the jug in the
specific site.
Use finer ingredients.
ate site.
Check that the whisk has
been installed and posi-
tioned properly.
Use cold milk.
Make sure the jug is dry and
clean.
Assemble the serrated whisk.
Do not use milk that was
frothed or heated.
Use the proper type of milk.
Chop the ingredients before
inserting them or check the
preparation tips.