Place And Align Refrigerator And Freezer - Whirlpool SKT60 Serie Instrucciones De Instalación

Fasten the Top Trim to the Opening
1. Align the top grille assembly against the opening, so that it is
tight and flush with the front surface of the wall opening or
cabinetry.
2. From below and behind the top grille assembly, insert a pan-
head Phillips screw (J) through the predrilled center hole of the
top grille (B) and into the wall opening or cabinetry.
NOTE: Do not completely tighten the screw.
3. Using a carpenter's level, level the top grille assembly (B), and
shim as necessary.
NOTE: Shims are not provided with the trim kit.
4. Using two pan-head Phillips screws (J), fasten the top grille
assembly (B) by inserting a screw through the predrilled holes
at each end. Completely tighten the screws.
5. Completely tighten the center screw.
Fasten the Side Trim to the Opening
1. Using a carpenters level, make sure the sides are plumb, and
shim as necessary.
NOTE: Shims are not provided with the trim kit.
2. Using four pan-head Phillips screws (J) (two on each side),
fasten both the left-hand (E) and right-hand side trim pieces
(G) to the opening or cabinetry. Make sure the trim pieces do
not twist.
6

Place and Align Refrigerator and Freezer

WARNING
Excessive Weight Hazard
Use two or more people to move and install
refrigerator.
Failure to do so can result in back or other injury.
When Moving Your Freezer or Refrigerator:
Your freezer and refrigerator are heavy. When moving the
appliance for cleaning or service, be sure to cover the floor
with cardboard or hardboard to avoid floor damage. Always
pull the appliance straight out when moving it. Do not wiggle
or "walk" the appliance when trying to move it, as floor
damage could occur.
1. Place the freezer and refrigerator in front of the opening
(freezer on the left, refrigerator on the right).
2. Remove the plastic base grille from each appliance by
removing the two Phillips screws.
A. Screw locations
A