Serial Terminals Connection - Sanyo PID-42NE1 Instrucciones De Instalación

Connections

SERIAL Terminals connection

The SERIAL terminal is used when the Display is controlled by a computer.
COMPUTER
Notes:
• Set up the computer to be connected and the communication RS-232C cross cable that connects the SERIAL terminal
with the computer.
• The computer shown is for example purposes only.
• Additional equipment and cables shown are not supplied with this set.
The SERIAL terminal conforms to the RS-232C interface
specification, so that the Display can be controlled by a
computer which is connected to this terminal.
The computer will require software which allows the
sending and receiving of control data which satisfies
the conditions given below. Use a computer application
such as programming language software. Refer to the
documentation for the computer application for details.
Communication parameters
Signal level
Synchronization method
Baud rate
Parity
Character length
Stop bit
Flow control
Basic format for control data
Add parameters as necessary depending on the control
content.
Commands shall be 1 command / 1 line that start with "C"
and end with the carriage return (0x0D).
A space is entered between the command "CF" and the
control instruction.
A space is entered between the command and the
parameter.
Ex) CF_POWER_ON[CR]
_ : space
Notes:
• If a correct command is sent, this unit will send a "000"
command to the computer.
• If an incorrect command is sent by mistake, this unit will send
a different command apart from "000" to the computer.
• While the power is in "stand-by" mode (power turned off
with remote control), all operations except "CF POWER
ON" will not respond.
12
RS-232C Cross cable
D-sub 9p
RS-232C compliant
Asynchronous
9600 bps
None
8 bits
1 bit
-
(Male)
(Female)
Signal names for D-sub 9P connector
Pin No.
2
3
5
4 • 6
7
8
1 • 9
These signal names are those of computer specifications.
Command
Command Parameter
CF POWER
ON
OFF
CF VOLUME
**
UP
DN
CF MUTE
UP
ON
OFF
CF INPUT
UP
AV1
AV2
AV2YPBPR
AV2RGB
PC
DVI
HDMI1
HDMI2
CF SCREEN UP
FULL
NORMAL
ZOOM
ZOOM2
1 2 3 4 5
6 7 8 9
Pin layout for SERIAL Terminal
Details
R X D
T X D
GND
Non use
(Shorted in this set)
NC
Control details
Power ON
Power OFF
000 - 100 *3 digits
Directly assigns volume level
Current volume level +1
Current volume level –1
Toggle to select
Audio MUTE ON
Audio MUTE OFF
Toggle to select between:
AV1 ➞ AV2➞ PC ➞ DVI ➞ HDMI1 ➞
HDMI2 ➞ AV1 ➞...
VIDEO input
Component/RGB input
Component input
RGB input
PC input
DVI input
HDMI1 input
HDMI2 input
Toggle to select between:
FULL ➞ NORMAL ➞ ZOOM1 ➞
ZOOM2 ➞ FULL ➞...
Full screen
Normal screen
Zoom 1
Zoom 2