Maintenance Instructions; Moving And Storage Instructions - Bahco BBCE12-15S Manual Del Propietário

FULLY CHARGED - AUTO MAINTAINING (Green LED pulsing) – Plugged into the AC
outlet and correctly connected to a fully charged battery.
CHARGE ABORTED - BAD BATTERY (Green LED flashing) – Circumstances that could
cause an Abort situation during charging:
• The battery is severely sulphated or has a shorted cell and can't reach a full charge.
• The battery is too large or there is a bank of batteries and it doesn't reach full charge within
a set time period.
Circumstances that could cause an Abort situation during maintaining the charge:
• The battery is severely suphated or has a weak cell and will not hold a charge.
• There is a large draw on the battery and the charger has to supply its maximum maintain
current for a 12-hour period to keep the battery at full charge.
BATTERY DISCONNECTED (No LED lit) – Clamps were unplugged during charging.
CHARGE MODE – PRESS FOR POWER SUPPLY MODE – DOUBLE CLICK TO
CONFIRM (No LED lit) – Plugged into the AC outlet, and charger mode is selected. Double
click the button to enter the charger mode.
POWER SUPPLY MODE – PRESS FOR CHARGE MODE – DOUBLE CLICK TO
CONFIRM (No LED lit) – Plugged into the AC outlet, and power supply mode is selected.
Double click the button to enter the power supply mode.
EXTERNAL BATTERY VOLTAGE TOO HIGH (No LED lit) – The external battery voltage
is more than the unit with power supply mode.
POWER SUPPLY ON (Green LED lit) – Plugged into the AC outlet, and the unit is working
in power supply mode.
OFF (No LED lit) – During the charger process or power supply process, press the button
once to stop the charger or power supply. The display will show OFF and then the selected
mode.

14. MAINTENANCE INSTRUCTIONS

14.1 Cleaning and user maintenance should not be done by children without supervision.
14.2 After use and before performing maintenance, unplug and disconnect the battery charger
(see Sections 6, 7 and 8).
14.3 Use a dry cloth to wipe all battery corrosion and other dirt or oil from the battery
connectors, cords and the charger case.
14.4 Ensure that all of the charger components are in place and in good working condition, for
example, the plastic boots on the battery clips.
14.5 Servicing should be performed by qualified service personnel.
14.6 If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or
similarly qualified persons, in order to avoid a hazard.

15. MOVING AND STORAGE INSTRUCTIONS

15.1 Store the charger unplugged, in an upright position. The cord will still conduct electricity
until it is unplugged from the outlet.
15.2 Store inside, in a cool, dry place.
15.3 Do not store the connectors clipped together, on or around metal, or clipped to cables.
15.4 If the charger is moved around the workshop or transported to another location, take care
to avoid/prevent damage to the cords, connectors and charger. Failure to do so could
result in personal injury or property damage.
• •
10