Display Messages - Bahco BBCE12-15S Manual Del Propietário

Cargador de batería automático con modo de alimentación
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 23
BATTERY CHARGING TIMES
CCA = Cold Cranking Amps Ah = Amp Hour
Battery Size/Rating
Cars and Trucks
Marine/Deep-cycle
Times are based on a 50% discharged battery and may change, depending on the age and condition of the
battery.
AUTOMATIC CHARGING MODE
When an Automatic Charge is performed, the charger switches to the Maintain Mode
automatically after the battery is charged. For a battery with a starting voltage under 1 volt,
use a manual charger to pre-charge the battery for five minutes, to get additional voltage into
the battery.
ABORTED CHARGE
If charging cannot be completed normally, charging will abort. When charging aborts, the
charger's output is shut off, the GREEN LED will flash and the display will show CHARGE
ABORTED - BAD BATTERY. Do not continue attempting to charge this battery. Check the
battery and replace, if necessary.
CHARGE COMPLETION AND MAINTAIN MODE (FLOAT MODE MONITORING)
Charge completion is indicated by the pulsing GREEN LED and the digital display
showing FULLY CHARGED - AUTO MAINTAINING. This indicates that the charger has
switched to the Maintain Mode of operation. In this mode, the charger keeps the battery
fully charged by delivering a small current when necessary.
NOTE: If the charger has to provide its maximum maintain current for a continuous 12-hour
period, it will go into Abort Mode (see the Aborted Charge section). This is usually caused by
a drain on the battery, or the battery could be bad. Make sure that there are no loads on the
battery. If there are, remove them. If there are none, have the battery checked or replaced.
MAINTAINING A BATTERY
The BBCE12-15S maintains 12-volt batteries, keeping them at full charge. It is not
recommended for industrial applications.
NOTE: The maintain mode technology allows you to safely charge and maintain a healthy battery
for extended periods of time. However, problems with the battery, electrical problems in the
vehicle, improper connections or other unanticipated conditions could cause excessive current
draws. As such, occasionally monitoring your battery and the charging process is recommended.
FAN
Your charger is equipped with a fan. It is normal for the fan to run while the charger is charging.
Keep the area near the charger free of obstructions, to allow the fan to operate efficiently.

13. DISPLAY MESSAGES

CONNECT CLAMPS (No LED lit) – Plugged into the AC outlet without the clamps
connected to a battery.
WARNING - CLAMPS REVERSED (No LED lit) – Plugged into the AC outlet and the
clamps are connected backwards to a battery.
ANALYSING BATTERY (Green LED lit) – Plugged into the AC outlet, and when first
correctly connected to battery.
CHARGING - XX% (Green LED lit) – Plugged into the AC outlet and correctly connected to
a discharged battery.
200-315 CCA
315-550 CCA
550-1200 CCA
9
Charge Time (15 A)
40-60 Ah
60-85 Ah
85-230 Ah
80 Ah
140 Ah
160 Ah
230 Ah
1
/
- 2
/
h
1
1
3
3
2
/
- 3 h
1
3
3
/
- 5
/
h
1
2
3
3
3 h
5 h
5
/
h
1
2
7
/
h
1
2

Publicidad

Tabla de contenido
loading

Tabla de contenido