Bahco BBCE12-15S Manual Del Propietário página 8

CHARGING
1. Ensure that all of the charger components are in place and in good working condition.
2. Connect the battery, following the precautions listed in Sections 6 and 7.
3. Connect the AC power following the precautions listed in Section 8.
4. When the charger starts, the GREEN LED will be solid, and the display will show
ANALYSING BATTERY while the charger determines that the battery is properly
connected and the condition of the battery.
5. When the battery is fully charged, the GREEN LED will pulse.
6. When charging is complete, disconnect the AC cord from the supply mains, remove the
clamp from the vehicle's chassis, and then remove the clamp from the battery terminal.
POWER SUPPLY
1. Ensure that all of the charger components are in place and in good working condition.
2. Connect the battery, following the precautions listed in Sections 6 and 7.
3. Connect the AC power following the precautions listed in Section 8.
4. When the power supply starts, the GREEN LED will be solid, and the display will show
POWER SUPPLY ON.
MEMORY SAVER FUNCTION
Before removing the vehicle's battery, review all of the battery
WARNING
manufacturer's safety instructions, warnings and directives regarding
battery disconnection, removal and replacement.
When using the BBCE12-15S as a memory saver, the charger clamps will
IMPORTANT
be connected to the vehicle's positive and negative terminals, NOT to the
battery.
1. Connect the charger's POSITIVE (RED) clamp to the vehicle's POSITIVE terminal (NOT
the battery post.)
2. Connect the charger's NEGATIVE (BLACK) clamp to the vehicle's NEGATIVE terminal
(NOT the battery post).
3. Connect the charger to the AC mains.
4. Press the button to select Power Supply mode, and then double-click to enter the mode.
When the power supply starts, the GREEN LED will be solid, and the display will show
POWER SUPPLY ON.
5. Make sure that the charger's negative clamp is well connected to the vehicle's
negative terminal. Disconnect the negative battery terminal from the negative battery
post.
6. Make sure that the charger's positive clamp is well connected to the vehicle's
positive terminal. Disconnect the positive battery terminal from the positive battery post.
7. Cover the positive and negative terminals with an insulator, such as electrical tape. This
prevents the connectors from touching metal, each other or the chassis, and causing a
short circuit.
8. Replace the old battery with the new battery.
9. Uncover and connect the vehicle's positive terminal to the POSITIVE (POS, P, +) battery
post.
10. Uncover and connect the vehicle's negative terminal to the NEGATIVE (NEG, N, -)
battery post.
BATTERY CONNECTION INDICATOR
If the charger does not detect a properly connected battery, charging will not start and the digital
display will show one of two messages. If the display shows CONNECT CLAMPS, make sure
that the charger is connected to the battery and the connection points are clean and making
a good connection. If the display shows WARNING - CLAMPS REVERSED, unplug the
charger from the AC outlet, reverse the connections at the battery, and then plug the charger
back in.
• •
8