Facom WV.1102 Guía De Instrucciones página 6

GB
1
3
3 - Remove the plastic plug protecting the air inlet tap.
4 - Screw the quarter inch quick-fit male union
into the air inlet port.
6
6 - Connect the hose to the jack to be operated,
using the female half coupler WA.1166FSB.
8
8 - To decompress, press the raised part of the
pedal. If the pump is connected to a push jack, the
jack rod will retract.
2
2 - Chek the pump oil level by unscrewing the oil filler cap.
The oil should come to 30 mm from the edge of the hole.If
the oil level is low, top up using the
5
5 - The compressed air supply must be through an air
pipe with a minimum inside diameter of 10 mm, and
one provided with a quick-fit female union. FACOM
recommands in particular the
NBB.103
N.622 (length : 10 m) extensions. Connect the air pipe
quick-fit union to the male union on the WV.1102.
7
7 - With the hand or foot, press the lower part of
the pedal: your pump is now working. If it is
connected to a push jack, the jack rod will extend.
WA.21 oil only.
N.620 (length : 5 m) and