Led Indicator; How To Use - Inateck BR1006 Manual De Instrucciones

LED Indicator

LED Indicator (TX Mode)
Rapidly Flashing blue
Blue LED flashes twice every 3 seconds
Blue LED flashes 4 times every 10 seconds
Blue LED flashes 3 times every 10 seconds
Blue LED flashes twice every 10 seconds
Blue LED flashes once every 10 seconds
Solid green

How to Use

1. Pairing
1) Set your Bluetooth enabled devices like Bluetooth headphones or
speakers to pairing mode.
2) Set the BR1006 to TX mode. Then press and hold the Multifunction
Button for 3 seconds to turn it on. Tap the Multifunction Button twice
to enter pairing mode with the LED indicator keeps rapidly flashing
blue. The BR1006 will automatically exit pairing mode if there is no
device to be connected within 2 minutes.
3) Place your Bluetooth audio receiving devices like earphones or
speakers closely to the BR1006. After approximately 30 seconds,
pairing will be completed. The BR1006 LED indicator will turn solid
blue.
4) Connect the BR1006 to your audio output devices like TV through a
3.5mm audio cable.
Status
In pairing mode
Automatically Pairing with Previously Paired
Devices
Successfully paired with aptX HD
Successfully paired with aptX low latency
Successfully paired with aptX
Successfully paired with SBC
Pair with two devices at the same time
4