Inateck BR1006 Manual De Instrucciones página 8

How to Use
1. Pairing
1) Set the BR1006 to RX mode before turning it on.
2) Turn on the BR1006 by pressing and holding the Multifunction Button
for 3 seconds. Rapidly tap the Multifunction Button twice to enter
pairing mode with the LED indicator flashes blue and red alternately.
3) Activate the Bluetooth function on your transmitting device and find
"Inateck BR1006" to connect. The LED indicator will turn solid blue
after successfully paired.
4) Connect the BR1006 to your headphone or home stereo playback
device through a 3.5mm audio to enjoy the music.
Note
a. If a PIN code is required for pairing, try 0000, 8888, 1111 or 1234.
b. This product has no built-in microphone which cannot be used for
hands-free calls.
c. BR1006 can remember 8 paired devices, when the number of paired
devices exceeds 8, the first one will be replaced.
2. Pair with two devices at the same time
In RX mode, BR1006 is able to pair with two Bluetooth enabled
smartphones/tablets at the same time. Only one device can play music
at any time. You have to stop the music on one device to play on the
other. Please follow the instructions below:
1) Follow the previous instructions in the "Pairing" section to pair the
BR1006 with your first device. Disable the Bluetooth function on your
first device after successfully pairing BR1006 with it.
2) Rapidly tap the Multifunction Button twice to pair and connect to
your second device
3) Turn off the BR1006 after successfully pairing it with your second
device. Activate the Bluetooth function on your first device, turn on
the BR1006 after about 20 seconds. After approximately 30 seconds,
pairing will be completed. The BR1006 LED indicator will turn solid
green.
7