Networking The Pdu - Tripp-Lite AGPD6684 Serie Manual Del Propietário

Installation
2-3
Equipment Power Cord Connection:
Insert the IEC C14 connectors
equipment power cords into the PDU's
IEC C13 output receptacles
near each output receptacle
C
illuminates when the receptacle is ready
to distribute live AC power. The digital
load meter
connected equipment load in amps.
2-4
Optional Cord Retention Procedure:
Use the included C14 sleeves to secure
plugs to receptacles. Attach the sleeve to
the plug, making sure that the pull tabs
remain outside the plug and that the
A
fit is secure. To unplug equipment
properly, use the pull tabs to remove the
plug and sleeve from the receptacle.

Networking the PDU

Note: The MAC address of the PDU (a 12-digit string in this format: 000667xxxxxx) is printed on a label attached to the PDU
enclosure. The MAC address is also printed on a label attached to the internal network card.
If your network's DHCP server will assign a dynamic IP address to the PDU automatically, go to
Step . If you will assign a static IP address to the PDU manually, go to Step
3-1
uncertain which method to use, contact your network administrator for assistance before
continuing the installation process.
Dynamic IP Address Assignment
3-1
Connect PDU to Network: While the
PDU is powered, connect a standard
Ethernet patch cable to the RJ-45
Ethernet port
Note: This port is not compatible with PoE (Power over
Ethernet) applications.
The PDU will attempt to obtain an IP
address via DHCP . This may take as long
as several minutes, depending on your
network environment.
3-2
Discover IP Address: Contact your network administrator to determine which dynamic IP
address has been assigned to the PDU by the DHCP server. The PDU can be identified on
the DHCP server by referring to its MAC address. (The MAC address is a 12-digit string in
this format: 000667xxxxxx. Refer to the MAC address label attached to the PDU.) You may
wish to request a long-term lease period for the IP address, depending on your application.
After you have discovered the IP address, skip Steps
Step .
5-1
Static IP Address Assignment
4-1
Determine IP Information: Before assigning a static IP address, you'll need to know the IP
address, gateway address and subnet mask. If you do not have this information, contact
your network administrator for assistance.
15-04-186-93341D.indb 5
of the
A
. The LED
B
will display the total
D
on the PDU.
A
A
2-3
A
2-4
A
3-1
and and proceed directly to
4-1 4-2
5
B
15
D
C
. If you are
4-1
4/16/2015 9:19:51 AM