Testing Network Connection - Tripp-Lite AGPD6684 Serie Manual Del Propietário

Installation
4-2
Configure Terminal Emulation
Program: Open a VT100-compatible
terminal emulation program (such as the
HyperTerminal program bundled with
Microsoft Windows
®
an available DB9 serial port. (A notebook
computer may be the most convenient
choice.) Set the terminal emulation
program to use the COM port
corresponds to the computer's DB9 serial
port. Specify the parameters
to communicate with the PDU terminal
interface:
B
its per second: 9600
Data bits:
Parity:
Stop bits:
Flow control:
If the terminal emulation program
supports multiple emulation modes, you
may also need to specify VT100
emulation .
C

Testing Network Connection

5-1
Access PDU with Web Browser: After
an IP address has been assigned to the
PDU, attempt to access it with a Web
browser that supports frames, forms and
Java™. Open a Web browser on a
computer connected to the LAN and
enter the IP address assigned to the PDU.
You should be prompted for a password
. The user name is localadmin and the
A
default password is localadmin. After you
enter the user name and password, the
PowerAlert Status page
the browser window. For more information
about configuration and operation of the
PDU via the PowerAlert Web browser
interface, refer to the SNMPWEBCARD
Installation Guide. You can find the guide
by going to www.tripplite.com/support and
typing "SNMPWEBCARD" in the search
field.
Note for Network Management System Users Only:
Two MIB files - Tripplite.mib and RFC1628.mib - must
be loaded on each Network Management Station that
will monitor the PDU via SNMP .
15-04-186-93341D.indb 6
) on a computer with
®
that
A
required
B
8
None
1
None
will appear in
B
A
B
C
A
B
6
4/16/2015 9:19:51 AM