Braun Aesculap Acculan 3Ti Instrucciones De Manejo página 14

®
Aesculap Acculan 3Ti
Acculan 3Ti small drill GA671
Note
The motor found within this Acculan 3Ti hand piece is
powered by a magnetic system. To ensure that the
motor of this powered instrument does not inadver-
tently activate, do not allow the hand piece to come in
contact with any magnetic sources (i.e. magnetic
instrument pads). Please note that having the safety
switch in the locked position does not assure that the
motor will not run inadvertently.
Note
The low whistling noise at startup of small drill 6 is nor-
mal for this product!
To run small drill 6 in clockwise rotation mode:
►
Press rotational speed control button 8, see Fig. 12.
Small drill 6 is controlled continuously to run at a
speed appropriate for the present attachment.
To run small drill 6 in counterclockwise rotation mode:
►
Fully press/actuate first the button for counter-
clockwise rotation 7 and press speed control but-
ton 8, see Fig. 12.
Small drill 6 is controlled continuously to run at a
speed appropriate for the present attachment.
12
Oscillating or tapping mode
►
To activate the oscillating or tapping mode: Press
counterclockwise rotation button 7 for 3 s,
see Fig. 12.
The drill issues a short acoustic signal.
►
To activate left rotation: Press the rotational speed
control button 8 in addition to the counterclock-
wise rotation button 7, see Fig. 12.
Small drill 6 runs counterclockwise.
►
To activate tapping mode: Press trigger 8 within
the first half of its total travel range, see Fig. 12.
Small drill 6 alternately runs counterclockwise and
clockwise, with the clockwise angle of rotation
always larger than the counterclockwise angle of
rotation.
►
To activate oscillating mode: Press trigger 8 within
the second half of its total travel range, see Fig. 12.
Small drill 6 alternately runs counterclockwise and
clockwise.