operating instructions, tips
Time selection
5
button
select Cycle
6
Option
start/pause
7
selection button
power button
8
If you insert laundry into your dryer while it is extremely tangled immediately after your washer has
finished a wash or spin cycle, it may degrade the drying efficiency or cause the door to open. We
recommend that you disentangle your laundry appropriately before inserting it.
Each indicator on the graphic display means:
26_ operating instructions, tips
F900A DRY_DV50F_USER MANUAL_DC68-03170D-03_EN.indd 26
When using Manual Dry cycles, you can adjust the drying time by pressing the
time selection button.
During the Sensory Dry cycle, the time light indicator is off because exact
drying times are determined by fluctuating humidity levels.
Therefore, the actual drying time may differ from the displayed time.
Anti Static – To reduce statics by clothing friction and spray steam at the later
period of drying cycle.
It is only available with: Normal, Heavy Duty, Perm Press, Delicates (Dry level
of every course exceeds Normal) and Time dry course.
In order to reduce statics, the drum can be paused during operation.
Rack Dry – Rack Dry is available at Time Dry cycle. Temperature will be set
only to Extra Low.
Small Load Care
(DV50F9A8E(G)*) – To control operation rate for drying a
Tm
small loads at Sensor Dry course.
It is only available with: Normal, Heavy Duty, Perm-Press and Delicates course.
It can't be selected/cancelled when the drying course is running.
In order to improve drying effect and control operation rate, the drum can be
paused during operation.
Drum Light – Lights the dryer drum while the dryer is running. (See page 26
for detail.)
my Cycle – Choose your favorite cycle including, temp, dry level.
Adjust Time – You can add or subtract time from the automatically set times
in the Wrinkle Release cycle and the Manual Dry cycles (Time Dry, Quick Dry,
Rack Dry or Air Fluff cycles.)
To add or subtract time from the cycle, press the Adjust Time arrow pad up or
down until the desired time is displayed.
Wrinkle prevent - Wrinkle Prevent provides approximately 180 minutes
of intermittent tumbling in unheated air at the end of the cycle to reduce
wrinkling. Press the Wrinkle Prevent button to activate this feature.
The indicator light above the pad will illuminate when you select Wrinkle Prevent.
The load is dry and you can remove it at any time during the Wrinkle Prevent cycle.
mixed Load bell - The mixed load bell that notifies you when the average
dry level in a load is damp dry (80 % dried). This lets you take garments that
you don't want fully dried or that dry quickly out of the dryer early while letting
others continue to dry. You can select this function in all Sensor Dry cycles
except Sanitize. The dry level selections are limited to Normal Dry, More Dry,
and Very Dry.
* Some options may not be selected simultaneously.
Press to pause and restart programs.
Press once to turn your dryer on, Press again to turn it off. If you turn
your dryer on and do not touch any buttons for 10 minutes, the power
automatically turns off.
Steam
Child Lock
Filter Check
Vent Sensor
2013-12-16 19:02:49