Behringer XENYX QX2222USB Guia De Inicio Rapido página 17

(1) USB wireless input accepts a USB receiver for
use with BehringerULM wireless microphones.
(2) GAIN knob adjusts the sensitivity of the MIC
and/or LINE inputs.
(3) COMP knob adjusts the amount of
compression effect on the channel.
(4) EQ knobs adjust the high, mid and low
frequencies of the channel. Adjust the FREQ
knob to select the specific frequency adjusted
by the MID knob.
(5) AUX knobs adjust how much of the channel's
signal routes to the AUX SEND jacks.
Press the PRE button when routing the
signal to a stage monitor. Use the FX knob
to send the channel's signal to the internal
multi-FX processor.
(6) PAN/BAL knob positions the channel in the
stereo field.
(7) MUTE button mutes the channel.
(8) CLIP LED lights when the channel
signal overloads.
(9) CHANNEL FADER adjusts the channel volume.
AC IN accepts the included power cable for
(10)
connection to a mains outlet.
POWER ON switch turns the mixer on and off.
(11)
PHANTOM ON switch sends 48 V to the XLR
(12)
inputs for use with condenser microphones.
MULTI-FX PROCESSOR adds a selected sound
(13)
effect to any channels whose FX knob is
turned up. See the Multi-FX Processor section
for details.
AUX SENDS adjust the amount of signal
(14)
sent to a monitor speaker or external effects
processor via the AUX SEND jacks.
AUX RETURNS adjust the amount of
(15)
signal returning from an external effects
processor that is included in the main mix.
Use the TO AUX SEND knob(s) to include the
effects signal in your monitor mix as well.
SOURCE buttons route the USB/2-TR, SUB,
(16)
and MAIN MIX to the PHONES and CONTROL
ROOM jacks.
USB/2-TR TO MAIN button routes the
(17)
USB and 2-TRACK signal to the MAIN MIX.
PHONES/CTRL ROOM knob adjusts the
(18)
headphone or studio monitor volume.
VU METER displays the MAIN OUTPUT
(19)
signal level.
MODE button determines whether
(20)
the channel's SOLO button operates as
'Solo in Place' (button out) or 'Pre-Fader
Listen' (button in). PFL is preferred for gain
setting purposes.
SUB faders adjust the output of the
(21)
SUB OUTPUT jacks. Use the LEFT/RIGHT
buttons to assign the SUB signal to the left
and/or right MAIN MIX.
MAIN MIX faders adjust the overall output of
(22)
the mixer.
17
Quick Start Guide