Important Safety Instructions For Installation And Use; Assembly And Installation; Electrical Connections; Safety Rules - Mottura POWER 541 Manual De Instrucciones, Uso Y Mantenimiento

I
MPORTANT SAFETY INSTRUCTIONS FOR INSTALLATION AND USE
The installation and electrical connections must only be carried out by qualified technicians, with suitable
equipment and under safety conditions, following the instructions given in this manual.
The system must be installed so that the motor unit is at a minimum height of 2.5m above ground (or from the
nearest access surface).
The button that operates the system must be installed outside operating area, at a minimum height of 1.5m
above ground (or from the nearest access surface) and within sight of the system.
All routine or extraordinary maintenance must be performed solely by qualified technicians after disconnecting
the system from the electrical power supply.
If any work needs to be done occupying the system operating space (e.g. cleaning glass, removing fabric, etc.)
prevent all possible activation of the system operating devices or disconnect the system from the electrical power
supply.
Only original parts must be used if any parts need to be replaced. Any use of non-original parts and any adaptation
or tampering will relieve Mottura S.p.A. of all liability for injury to persons or damage to property.
Do not let children play with the operating devices. Keep the devices out of their reach.
Make periodic checks of all mechanical and electrical parts. Take steps to prevent the system from being used if
maintenance has to be done.
During normal system use, monitor its movement. Prevent anyone from entering the system operating space
until it is completely stopped.
Attachments "A" - "B" - "C" - "D" - "E" provide instructions for correct assembly and installation of the
Power 541.
To fasten the supports, use anchors or screws suitable for the type of structure on
which the system will be installed.
Make certain that the structure is adequately sized for the weight of the system.
The motor must be connected to the electrical grid, to the drive devices, and to any outside
units by trained personnel only.
DO NOT work on the motor when it is powered. Before doing any work, disconnect the
system from the electrical grid in such a way that it stays disconnected until all work is
finished.
P 541/1
OWER
E
LECTRONIC MOTOR WITH RADIO RECEIVER AND CONTROL BY WIRE TYPE
Attachments "F" - "G" provide instructions for correct connection of the Power 541/1 system with the "2+3 wires"
method (power supply and controls in separate systems). In this case, you can create single and simultaneous
controls via wire.
P 541/2
OWER
M 3
OTOR WITH WIRES
Attachment "L" provide instructions for correct connection of the Power 541/2 system with the "3 wires"
method (power supply and controls in the same system).
Never connect two or more Power 541/2 in parallel on the same button exchange or on the same output
of a control box or of a R.F. receiver (see attachment "L").
Where a button is used for direct Power 541/2 control (no control box), use Art. 5096 or Art. 5097 -
buttons, 10A with two contacts, interlock and central OFF.
6
A
SSEMBLY AND INSTALLATION
E
LECTRICAL CONNECTIONS
90-250 V
AC CONTROL

SAFETY RULES

" "
DRY CONTACT
En 2
Z 253/1 rB