Power 541/1; Power 541/2; Control; Automatic Limit Switches Setting - Mottura POWER 541 Manual De Instrucciones, Uso Y Mantenimiento

E
LECTRONIC MOTOR WITH RADIO RECEIVER AND CONTROL BY WIRE TYPE
C
ONTROL
You can control the Power 541/1 in the following ways:
AutoStart ® : When the curtain is pulled in one direction, the motor is automatically activated and reaches
•
the corresponding limit switch. It isn't adviced to stop the curtain manually for the possibility of damaging the
fabric.
Control by wire with "Dry Contact" buttons (optional): when pressing a command, the motor starts and
•
reaches the corresponding limit switch. It's possible to stop the motor by pressing the command of STOP or
that of the direction contrary to running.
Control with M2net RF transmitters (optional): Upon receipt a RF command, the motor starts and reaches
•
the corresponding limit switch. It's possible to stop the motor by sending the command of STOP or that of the
direction contrary to running.
Control by PC / Smartphone (optional unit): Upon receipt a command, the motor starts and reaches the
•
corresponding limit switch. it's possible to stop the motor by sending the command of STOP or that of the
direction contrary to running.
The different ways of control are compatible with each other and can coexist in the same installation. You can't
use the AutoStart ® only but it is necessary to provide the system with at least a button or a
transmitter.
In case of balckout it's possible to open / close the system manually by pulling the fabric in one of the two
directions. On return of power supply, the motor will automatically set the limit switches during the first runs.
A L S
UTOMATIC IMIT WITCHES SETTING
The Power 541/1 doesn't require any manual setting of its limit switches. The Power 541/1 automatically sets its
limit switches during the first runs (this happens also the first runs after a blackout).
During regular operation, the motor stops in advance (Advance Stop) compared to the limit switches stored so
as to preserve the fabric and the mechanical parts. This Advance Stop is automatically set by the electronics
during the setting of limit switches, but can be manually changed (if necessary).
There are 3 different settings of
same (2 mm) for FC1 and FC2
•
equal to 5% of the travel on FC1 and of 2 mm FC2
•
equal to 5% of the travel on FC2 and of 2 mm FC1
•
To know which setting of
1. Press the RESET button for 6 seconds.
2. Check in the following table which
the LED 1 and LED 2
3. If no change is necessary, press the button RESET otherwise, each time you press the RF button, you go
to the subsequent Advance Stop.
4. To confirm the Advance Stop setting, press the button RESET
Attention: If you press the RESET button when both LEDs flash, the limit switches are deleted and in the
subsequent runs the motor sets them again.
A RF
SSIGNING AN RADIO RECEIVER
To control the Power 541/1 by radio it must be assigned to a remote control. To perform this operation carry out
the following procedure (see attachment "I").
1. Put the transmitter into the association mode (consult the technical manual for the transmitter being used)
2. Press the RF button on the motor control panel for 8 seconds (one flash of the "RF" LED on the motor
control panel confirms that the association procedure has been carried out correctly).
P
OWER
Advance Stop (see
Advance Stop is effective, or eventually to change it, follow the procedure below:
Advance Stop
L1 + L2 FC1 – 2 mm
L1
L2 FC1 – 2 mm
(
P 541/1)
OWER
541/1
attachment "H"):
is effective in relation to the type of signal arising from
FC2 – 2 mm
FC1 – 5% FC2 – 2 mm
FC2 – 5%
En 3
Z 253/1 rB
" "
DRY CONTACTS
7