Assembly Instruction - SPORTSTECH X150 Manual

i
Remove all the part of your cycle from the carton and place them to the floor care-
fully. Assembling your cycle is simple. Follow these instructions carefully and it should
take you around 15-20 minutes.
Step 1 ATTACH THE STABILIZERS
The release knob (45) from the folded main frame (1) in the unplug, and then start open the machine,
and attach pin (40) into the hole after the main frame (1) open.
•
Attach rear stabilizer (6) with 2 adjustment end caps (5) to the welded cross bar
bracket of main frame (55) and fasten with 2 pvc washer (95), 2 curved washers
(2), spring washer (3) , 2 carriages bolts(1) and 2 cap nuts (4).
•
Attach front stabilizer (7) with 2 transportation wheels (8) to the welded cross bar
bracket of main frame (55) and fasten with 2 pvc washer (95), 2 curved washers (2),
spring washer (3), 2 carriage bolts (1) and 2 cap nuts (4).
•
Fasten each one piece tightly.

3. ASSEMBLY INSTRUCTION

27