Testing Your Fan - Ellington SUA62BNK5 Guia De Instalacion

10. Testing Your Fan.

It is recommended that you test fan before
finalizing installation. Restore power from circuit
box and light switch (if applicable). Test fan
speeds with the pull chain. Start at the OFF
position (no blade movement). First pull will set
the fan to HI. Second pull will set the fan to
MEDIUM-HI. Third pull will set the fan to
MEDIUM-LOW. Fourth pull will the fan to LOW.
Fifth pull will again set the fan to OFF setting.
(diagram 1) If fan does not function, please refer
to "Troubleshooting" section to solve any issues
before contacting Customer Service.
Turn fan completely off before moving the
reverse switch. Set reverse switch to recirculate
air depending on the season:
- LEFT position in summer (diagram 2)
- RIGHT position in winter (diagram 3)
A ceiling fan will allow you to raise your
thermostat setting in summer and lower your
thermostat setting in winter without feeling a
difference in your comfort.
Important: Reverse switch must be set either
completely to the LEFT or completely to the RIGHT
for fan to function. If the reverse switch is set in
the middle position (diagram 4), fan will not
operate.
Attach pull chain extension supplied or custom
pull chain extension (sold separately) to the end
of the pull chain.
motor housing
switch housing
reverse
switch
diagram 1
diagram 2 diagram 3
pull chain
extension
diagram 4