Blade Assembly; Switch Housing Assembly - Ellington SUA62BNK5 Guia De Instalacion

8. Blade Assembly.

Time Saver: Washers for blade screws can be
set on each blade screw prior to installing
blades.
Locate 15 blade attachment screws and
washers in hardware pack. Hold blade arm up
to blade and align holes. Insert 3 blade
attachment screws (along with washers) with
fingers first and then tighten screws securely
with Phillips screwdriver. Repeat procedure for
the remaining blades.
Locate blade arm screws and lock washers that
were previously removed on page 4. Align
blade arm holes with motor screw holes and
attach one blade arm with lock washers and
blade arm screws. Before securing screws
permanently, repeat procedure with remaining
blade arms. Securely tighten all screws.
Note: Tighten blade arm screws twice a year.

9. Switch Housing Assembly.

Remove 3 screws from outer edge of switch
housing plate (save screws for later use).
Remove 1 screw from fitter plate on underside
of motor and partially loosen the other 2
screws. Align slotted holes in center of switch
housing plate with loosened screws in fitter
plate, allowing male plug from motor housing
to come through hole in middle of switch
housing plate. Twist switch housing plate to
lock. Re-insert screw that was removed and
secure all screws.
Connect male plug from motor housing to
female plug from switch housing. Make sure
plugs connect tightly.
Align holes in switch housing with holes in
switch housing plate. Re-insert screws that
were previously removed and use a Phillips
screwdriver to secure all screws.
motor housing
lock
washers
blade arm screws
fitter
plate
switch housing
page 7
blade attachment
screws and washers
blade
blade arm
motor
housing
male plug
switch housing plate
female plug