Getting Started - RCA ANT2000 Guia Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Getting Started

Setting Up the ANT2000
Find the best location for the Smart Antenna.
Before you connect the antenna, determine the best spot in your home for optimum reception.
Visit www.antennaweb.org to see where your local broadcasts are coming from. Then, try as
much as possible to avoid obstructions between these transmitters and your antenna.
Connect the Smart Module and Smart Antenna to your Converter Box.
Converter Box
Coaxial
Cable
2
ANTENNA
OUT TO TV
IN
4
SMART ANTENNA CONTROL
Smart Module
Built-In
Coaxial Cable
Smart Antenna
3. Connect the provided antenna control cable to the smart antenna jack on the back of your
converter box or TV. Connect the other end of the provided antenna control cable to the
ANTENNA CONTROL jack on the Smart Module.
Note: For additional information about setting up your converter box, visit www.keepmytv.com
4. Connect the Smart Antenna's built-in coaxial cable to the ANTENNA IN jack on the Smart
Module.
Note: The Smart Module should be used with this Smart Antenna only. Do not connect it to any other
type of antenna.

3
Antenna
Control
Cable
ANTENNA
CONTROL
1. Make sure your converter box is turned off.
2. Connect a coaxial cable to the antenna input
on your converter box or TV. Connect the
other end of the coaxial cable to the OUT TO
TV jack on the Smart Module.
Important Notes
Do not connect any other device between the Smart
Module and your converter box—the Smart Module
must be connected directly to your converter box or
TV to work properly.
The Smart Antenna should be used with a single
converter box or TV. Do not use it with a splitter.
See your converter box's owner's manual for more
detailed connection instructions.

Publicidad

Tabla de contenido
loading

Tabla de contenido