RCA ANT2000 Guia Del Usuario página 3

Coaxial Cable Installation Precautions
• Do not bend coaxial cables into less than a three-inch radius. Tighter bends can cause shorts
and can change a cable's impedance.
• Do not install a coaxial cable where it will have a pulling tension greater than 15 pounds
during installation. After installation, make sure there is no tension on the cable.
• Use only round-headed staples. Any clamps or securing devices used with coax should grip
the cable evenly about the circumference without crushing the cable. Flat staples can damage
the coaxial cable.
• Do not expose a coaxial cable to a temperature greater than 176 degrees Fahrenheit. Keep
the cable away from heating vents and water heaters.
Set up your Converter Box to work with the Smart Antenna.
1. Once you've followed the connection instructions for the Smart Antenna, turn your
converter box on.
2. Follow the instructions in your converter box's owner's manual to set its antenna type to
"Smart Antenna".
Specifications
Smart Antenna
Frequency
Gain
Directionality
Impedance
Polarization
Power Consumption
Smart Module
Frequency
Impedance
Antenna Control Jack Modular antenna control connector (CEA909)
470-806 MHz
10 dB
360º
75 Ohms (F-type)
Horizontal
12V DC
470-806 MHz
75 Ohms (F-type)
Getting Started