Samsung SCC-B2305 Manual De Utilización página 6

DAY/NIGHT External Signal Input & Alarm Signal Output
This is a function to receive the external DAY/NIGHT signal from the
sensor(option) and convert the signal into BW. The MOTION DET
E
function generates an alarm signal when a movement is detected.
DAY/NIGHT IN
GND
ALARM OUT
Connect an external sensor to the DAY/NIGHT terminal as shown in
connect any external device such as a buzzer or lamp to the ALARM
terminal as shown in .
The ALARM output terminal is an open collector with the following capacity:
DC 16V and 100mA.
OFF : Open contact
ON : Below 100mA
The DAY/NIGHT input terminal has the input of DC 5V pull-up and over
0.2mA.
OFF : Open contact
ON : Closed contact
10
Camera Operation Switch(Setup Switch)
The function of the camera operation switch changes depending on
whether the camera is currently in the usual operation mode(No setup
menu is seen on the screen) or the setup menu mode.
[UP/DOWN] key
then
[UP/DOWN] key : These keys move up or down the cursor.
[LEFT/RIGHT] key : These keys move the cursor to the left or right or
[ENTER] key : It is used to enter the Setup menu.(Press it about 2
Power Connection Port
This port is connected to the power(adapter) cable.
[LEFT/RIGHT] key
[ENTER] key
identify the values sequentially which can be
assigned in each setup menu.
seconds.)
It is used to enter a sub-menu of a setup menu by
clicking the setup menu or to set the current value.
E
11