Install The Hardware - Axis P3346-VE Guia De Instalacion

AXIS P33-VE Series Network Camera Installation Guide

Install the hardware

Note: Please remove the rubber band for transport-safety from the camera unit before you mount
the camera.
Prepare the network cable
If a cable other than the provided cable is used, you need to prepare a network cable with a gasket.
Gently force the cable through the gasket provided and attach a network connector. It may be
necessary to pierce a hole in the gasket with the resitorx screwdriver.
Notes:
• Do not force the network connector into the gasket.
• Do not pierce the gasket with a knife or other sharp object.
Prepare the unit casing (routing cables along the wall)
If the cables are to be routed along the wall, prepare the unit casing as follows:
1. Detach the side lid that is attached to the unit casing by removing the screw.
2. Loosen the two screws on the cable shield and detach the bottom part.
3. Attach the bottom part of the cable shield to the unit casing with the screw.
Unit casing
Screw
Side lid
Cable shield
Top part
Bottom part
Page 7
Unit casing