Sanitas SBM 07 Instrucciones Para El Uso página 15

6. Display of the readings saved
The computer automatically saves the blood pressure readings of the last 50 measurements.
When the 50 memory locations are exceeded, the current oldest value is deleted.
You can display the memory as follows:
• Press the "User-Switching key" to select a memory zone, and press the "M" key to switch from memory to
memory with sequence numbers.
• The saved measured values are continuously stored.
• To switch off, press the ON/OFF/START button again.
• If you forget to switch off the computer, it will switch off automatically after 1 minute.
Press the "User-Switching key" to select a memory zone, then press and hold the "M" key for approximately
5 seconds to clear the data in the pre-designated memory zone. The data in both memory zones – zone 1 and
zone 2 may be erased if any of the batteries is removed.
7. Error messages appear in the display if:
• cuff inflation takes longer than 20 seconds,
• you move during the measurement instead of relaxing quietly,
• insufficient pressure is reached despite extra inflation,
• the blood pressure readings are extremely high or low,
• the inflation pressure is higher than 300 mmgH,
• the batteries are almost exhausted, the batteries must then be exchanged.
In the event of error messages, wait for a short time and measure again.
15