Suunto Memory Belt Manual Del Usuario página 6

SIGNALS
The LED colors have the following meaning:
• Green light = normal operation
• Orange light = memory low or full
• Red light = battery low or empty
The beeps and color LED flashes indicating different states of Suunto Memory Belt are
described in the following table. The symbols in the beep and flash columns indicate the
length of the signal (short, medium-length or long).
NOTE: Suunto Memory Belt can give two long beeps for three different reasons. In this case,
check the color of the flash to find out the correct cause.
BEEP
(3 times)
(3 times)
4
FLASH
(green)
(green, every 4 seconds)
(green)
(green)
3 times, then 1 every
4 seconds (orange)
(orange)
3 times, then 1 every
4 seconds (red)
(red)
DESCRIPTION
Successful operation:
• Activated, starts recording
• Connected to PC
• New battery installed successfully
Measuring and recording
No heart rate detected for 30 seconds
Belt goes into sleep mode
Belt disconnected from PC
Memory low, still recording
Memory full, switching to sleep mode
Battery low, still recording and transmitting
Battery too low to operate, switching to sleep
mode (this applies also to PC connection)