A.
B.
C.
D.
E.
F.
CAPABILITIES
Will shred: Paper, credit cards, CD/DVDs, staples and small paper clips
Will not shred: Continuous forms, adhesive labels, transparencies, newspaper, cardboard,
large paper clips, laminates or plastic other than noted above
Paper shred size:
Strip Cut ................................................................................................................. 5.8mm
IMPORTANT SAFETY INSTRUCTIONS — Read Before Using!
set to off or unplug when not in use.
products on or near shredder. Do not use canned air on shredder.
Do not place near or over heat source or water.
manual. Read the entire instruction manual before operating shredders.
BASIC SHREDDING OPERATION
PAPER OR CD/CARD
1
Continuous operation:
NOTE: Shredder runs briefly
after each pass to clear entry.
Continuous operation beyond
Plug in and put
10-12-minutes will trigger
disconnect power
20-minute cool down period.
switch in ON (I) position
G.
H.
KEY
I.
J.
A. Indicator lights
K.
1. Overheat (red)
2. Bin Open (red)
3. Remove Paper (red)
Maximum:
Sheets per pass ........................................................................................................... 14*
Cards/CDs per pass ....................................................................................................... 1*
Paper entry width .................................................................................................. 229mm
* A4 (70g), paper at 220-240V/50 Hz, 1Amps; heavier paper, humidity or other than rated
voltage may reduce capacity. Recommended daily usage rates: 600 sheets per day; 25
cards; 10 CDs.
2
3
14
Check paper amount
Press Auto-On (I)
B. Paper entry
H. Safety lock
C. See safety instructions
D. Card/CD entry
E. Window
I. Auto-On (green)
F. Pull-out bin
J. Control switch
G. Disconnect power switch
1. OFF
2. ON
K.
14 sheets per pass.
position to operate shredder. In case of emergency, move switch to OFF (O)
4
5
or
14
14
Feed paper straight into
Feed into card/CD
paper entry and release
entry and release
ENGLISH
Model 70S
I
1. Auto-On
O 2. OFF
R 3. Reverse
Sheet capacity indicator
6
When finished
shredding set
to OFF (O)
2