Handling Fuel; Fuel And Lubricant - Shindaiwa 326T Manual Del Propietario - Operador

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

NOTICE: Use of unmixed, improperly mixed, or fuel older than 90 days, (stale fuel), may cause hard starting, poor per-
formance, or severe engine damage and void the product warranty. Read and follow instructions in the Storage section
of this manual.
FUEL STATEMENT
Alternative fuels, such as E-20 (20% ethanol), E-85 (85% ethanol) or any fuels not meeting Shindaiwa requirements
are NOT approved for use in Shindaiwa 2-stroke gasoline engines. Use of alternative fuels may cause performance
problems, loss of power, overheating, fuel vapor lock, and unintended machine operation, including, but not limited
to, improper clutch engagement. Alternative fuels may also cause premature deterioration of fuel lines, gaskets, car-
buretors and other engine components.
Gasoline: Use 89 Octane [R+M/2] (mid grade or higher) gasoline known to be good quality. Gasoline may contain up to
10% Ethanol (grain alcohol) or 15% MTBE (methyl tertiary-butyl ether). Gasoline containing methanol (wood alcohol) is
NOT approved.
Two Stroke Oil:
Oil is a registered JASO FC classified oil and also meets or exceeds ISO-L-EGD performance
requirements. Shindaiwa One is recommended for use in all Shindaiwa low emissions engines.Shindaiwa One also
includes a fuel stabilizer.
IMPORTANT
Mix only enough fuel for your immediate needs! If fuel must be stored longer than 30 days and
lizer is not used, it should first be treated with a fuel stabilizer such as STA-BIL™.

Handling Fuel

Fuel is VERY flammable. Use extreme care when mixing, storing or handling or serious personal injury may result.
Use an approved fuel container.
DO NOT smoke near fuel.
DO NOT allow flames or sparks near fuel.
Fuel tanks/cans may be under pressure. Always loosen fuel caps slowly allowing pressure to equalize.
NEVER refuel a unit when the engine is HOT or RUNNING!
DO NOT fill fuel tanks indoors. ALWAYS fill fuel tanks outdoors over bare ground.
DO NOT overfill fuel tank. Wipe up spills immediately.
Securely tighten fuel tank cap and close fuel container after refueling.
Inspect for fuel leakage. If fuel leakage is found, do not start or operate unit until leakage is repaired.
Move at least 3m (10 ft.) from refueling location before starting
12
f
l
uel anD
ubRiCant
WARNING
WARNING
DANGER
the engine.
oil with fuel stabi-

Publicidad

Tabla de contenido
loading

Tabla de contenido