Chain And Guide Bar Combinations - Shindaiwa 326T Manual Del Propietario - Operador

The following combinations may be used on 326T.
Model Bar Length
12"
326T 14"
16"
*Reduced nose radius symmetrical bars (OREGON name — Double Guard)
Use of replacement saw chain and/or guide bar other than that specified, or operation without the "tip guard" in place,
may cause severe kickback resulting in serious injury.
Only use saw chain designated as "LOW-KICKBACK" that meets the ANSI B175.1-2000 Standard and the guide bar
specified.
IMPORTANT
Chain and guide bar gauge size must be identical. Use Bar/Chain combinations shown in table above.
IMPORTANT
If your kick guard is damaged or lost, contact your Shindaiwa dealer for a replacement.
SETTING THE SAW CHAIN
For setting saw chains, round file (4 mm ø: 5/32") and flat file are used.
■
To keep correct position and correct angle, use the file holder.
-
Round file and flat file are available from your Shindaiwa Dealer.
■
File cutters as below.
30°
Keep this angle
PUSH FILE AS SHOWN
24
C g
hain anD uiDe
Low Kickback
Guard Bar
Bar P/N Chain P/N
120GPEA041 91VG-45
140GPEA041 91VG-52
160GPEA041 91VG-57
WARNING
Type : 91VG
HOLD FILE HOLDER LEVEL
To sharpen other type chain, follow chain manufacturer's instructions
b C
aR ombinations
Low Kickback Saw Chain
Links Type
45
52 91VG
57
DANGER
1/5
90°
ONE FIFTH OF FILE DIAMETER REMAINS
ABOVE CUTTER EDGE
Pitch Gauge
3/8" .050
Depth gauge