Displayed Messages - Barazza 1CFFY1 Manual De Instalacion Y Uso

DISPLAYED MESSAGES

DISPLAYED MESSAGE
FILL TANK!
GROUND TOO FINE ADJUST MILL AND
(alternating with)
PRESS OK
GROUND TOO FINE ADJUST MILL AND
(alternating with)
PRESS OK
(then)
FILL TANK!
EMPTY WASTE COFFEE CONTAINER
INSERT WASTE COFFEE CONTAINER
ADD PRE-GROUND COFFEE
PLEASE DESCALE!
LESS COFFEE
FILL BEAN CONTAINER
INSERT BREWING UNIT
CLOSE DOOR
POSSIBLE CAUSE
The water tank is empty or positioned
incorrectly.
The grinding is too fine and the coffee
is delivered too slowly.
The machine cannot make coffee as
there is air in the hydraulic circuit
Possible cause: the filter has not been
installed correctly.
The tank has been removed during
delivery.
The waste coffee container (A4) is too
full or more than 3 days have passed
since you last made coffee (this gua-
rantees correct hygiene of the machi-
ne).
After cleaning, the waste coffee con-
tainer has not been replaced.
The "pre-ground coffee" function has
been selected without placing any
pre-ground coffee in the funnel.
The funnel (A21) is blocked.
The machine must be descaled.
Too much coffee has been used.
The coffee beans have run out.
The brewing unit has not been repla-
ced after cleaning.
The service door is open
14
REMEDY
Fill the tank with water and/or insert it cor-
rectly, pushing it as far as it will go.
Turn the grinding adjustment knob one click
clockwise towards "7".
Make sure the filter (A26) is properly instal-
led and that the installation has been carried
out correctly.
Insert the tank and press the OK icon (B9).
"HOT WATER PRESS OK" is displayed.
Press the OK icon (B9) again.
The appliance is once again ready for use.
Empty the waste coffee container and clean,
then replace.
Important: when removing the drip tray, the
waste coffee container MUST be emptied,
even if it is not completely full.
If this is not done, when you make the next
coffees, the waste coffee container may fill
up more than expected and clog the ma-
chine.
Open the service door and insert the waste
coffee container.
Extract the appliance and place pre-ground
coffee in the funnel.
Empty the funnel with the help of a knife as
described in the section "Cleaning the pre-
ground coffee funnel".
The descaling procedure described in the
"Descaling" section needs to be performed
as soon as possible.
Select a milder taste or reduce the quantity
of pre-ground coffee, then make the coffee
again.
Fill bean container
Insert the brewing unit as described in the
section "Cleaning the brewing unit".
Close the service door.
EN