Assembly And Adjustments - POWER SMITH PCS140H Manual Del Operador

kNOWING YOUR CHAIN SAW
Speed Selector (9-FIG 6)
The chain saw can be running at two speeds. To select the speed, slide
the speed selector (9) forward for fast speed, backward for slow speed.
See FIG 7.
NOTE:
Using the saw with slow speed only reduces the chain speed
not the cutting power of the saw.
Low Kickback Saw Chain (1-FIG 6)
The low kickback saw chain helps minimize the force of a kickback
reaction by preventing the cutters from digging in too deeply at the
kickback zone.
Chain Catcher (16-FIG 6)
The chain catcher is designed to catch the chain if it snaps or jumps off. This should not happen if the chain is properly
tensioned and if the bar and chain are properly serviced and maintained.

ASSEMBLY AND ADJUSTMENTS

Warning:
disconnected before adjusting, adding accessories, or checking a function on the tool.
Warning:
those parts are replaced. Use of this product with damaged or missing parts could result
in serious personal injury.
Warning:
recommended for use with this chain saw. any such alteration or modification is misuse
and could result in a hazardous condition leading to possible serious personal injury.
INSTALLING THE GUIDE BAR AND CHAIN
Warning:
components are sharp and may contain burrs.
Warning:
chain is very sharp; always wear protective gloves when performing maintenance to the
chain to avoid possible serious lacerations.
The new chain saw comes with the guide bar and saw chain uninstalled. To install and adjust the guide bar and chain,
See instructions under the section: "REPLACING ThE BAR AND ChAIN" in the Maintenance section of this manual.
INSTALLING OR REMOVING THE BATTERY PACK (FIG 8)
IMPORTANT!
charged when it is purchased. Before using the chain saw
for the first time, charge the battery pack. Make sure to
read all safety precautions and follow the instructions in the
Charging Battery section.
Warning:
the tool is switched off before insertion or
removal of the battery pack.
always be sure that the tool is switched off and the battery is
if any parts are damaged or missing, do not operate this product until
Do not attempt to modify this product or create accessories not
always wear gloves when handling the bar and chain; these
Never touch or adjust the chain while the motor is running. The saw
The battery pack is not fully
always be sure that
English
FIG 8
13
FAST
SLOW
FIG 7
2
1