Side Angle Clamp; Axle - SNOWJOE SJGC7 Instrucciones De Seguridad

Assembly
Your garden + utility cart requires assembly. Account for all
parts and hardware before beginning assembly. If any parts
are missing or damaged, or if you have any questions or need
additional instructions, Please call the Snow Joe
customer service center at 1-866-SNOWJOE
(1-866-766-9563).
NOTE: When assembling your cart, place the heads of all
screws to the inside and hex nuts with flat washers to the
outside.
NOTE: The wheels may be sent in an under-inflated condition.
Use a standard bicycle pump to inflate as needed.
Tools needed:
• Wrench (included)
• Screwdriver (not included)
1. Lay the front angle clamp down (flat) on floor and stand
the bottom panel on the front angle clamp. Align the three
holes in the bottom panel with the three holes in the front
angle clamp (Fig. 1).
Fig. 1
Bottom panel
2. Push three M6 x 25 screws through the bottom panel and
the front angle clamp. Secure the screws with flat washers
and hex nuts, and tighten (Fig. 2).
Fig. 2
Hex nut
Flat washer
+ Sun Joe
® ®
Front angle clamp
M6 x 25
screws
4
3. Turn the front angle clamp and bottom panel upside
down, and lay the side angle clamps on the bottom panel
(Fig. 3).
Fig. 3
Side angle
clamp
4. Secure the axle clamps to the side angle clamps and
the bottom panel by using four M6 x 30 screws, lock
washers and hex nuts. Do not tighten until the axle is fully
assembled (Fig. 4).
Fig. 4
Hex nuts
Lock washers
Axle clamp
Hex nuts
Axle clamp
5. Secure the side angle clamps and bottom panel together
with four M6 x 25 screws, flat washers, and hex nuts.
Tighten the four nuts (Fig. 5).
Fig. 5
Hex nut
Hex nut
Flat
washer
Front angle
clamp
Bottom
Side angle
panel
clamp
Lock
washers
M6 x 30
screws
Flat
washer
M6 x 25
screws