Supporting Strap; Front Angle Clamp; Bottom Panel 11. M6 X 50 Screw (8) - SNOWJOE SJGC7 Instrucciones De Seguridad

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

6. Stand the cart on end with the front angle clamp down on
the floor. Temporarily place the four large flat washers on
the inside of the front angle clamp (Fig. 6).
Fig. 6
Large washers
7. Lay the front panel down onto the front angle clamp, on
top of the four large washers (Fig. 7).
Fig. 7
NOTE: The washers are used here as shims (spacers) and not
for assembly. They will be removed and used for wheel and
axle assembly.
8. Position a side panel against a side angle clamp, resting
on top of the front panel (Fig. 8).
Fig. 8
Side angle
clamp
Side panel
9. Secure a supporting strap on the side angle clamp and
the front angle clamp by two M6 x 25 screws, 2 flat
washer, and 2 hex nuts (Fig. 9).
Fig. 9
Side panel
Hex nuts
10. Secure the side panel with the side angle clamp by a
M6 x 25 screw, a flat washer, and a hex nut (Fig. 10).
Front panel
Fig. 10
Flat washer
Hex nut
Side angle
clamp
Bottom
11. Secure the side panel with the front angle clamp by a
panel
M6 x 25 screw, a flat washer, and a hex nut (Fig. 11).
Front panel
5
Side angle
clamp
Flat
washers
Front angle
clamp
Supporting
strap
M6 x 25
screw
Side
panel
Front
panel
M6 x 25
screw
Bottom
panel
Front
panel

Publicidad

Tabla de contenido
loading

Tabla de contenido