PEERLESS Vantage Manual De Instalación página 4

WALL SET INSTALLATION (Continued)
3. Dry Fit All Panels
◘
Dry fit all panels and tape in place, aligning top to pencil
line.
IMPORTANT! If bathtub is not level, trim bottoms of
panels to follow slope of bathtub.
TIP: To trim side and back panels, score with utility
knife and straight edge and snap apart. Scissors may
be needed to trim corner panels.
5. Dry Fit Side Panels
Align edge with bathtub
◘
Position side panels with tape.
IMPORTANT! Align front edge of side panels with front
edge of bathtub. A space should remain in the corners
for corner panel installation.
◘
Trace side panels on wall.
◘
Remove panels.
IMPORTANT! The corner panels may overlap the side
panel.
Back
panel
Left side
panel
Left corner
panel
4. Prepare for Plumbing Fixtures
Y
◘
Measure and mark location for plumbing fixtures on back
of side panel.
◘
Using proper size hole saw, cut out plumbing fixture holes
from back side of panel.
6. Install Side Panels
APPLY ADHESIVE using trowel, staying within pencil lines.
◘
Press and tape each panel to wall.
IMPORTANT! If using solvent-based adhesive, pull
panel away from wall for 30 seconds to allow solvents to
escape. Re-press panel fi rmly against wall.
4
Y
X
Pencil line
B27778 Rev. B 5/9/16
Drill holes
from back.
X