PEERLESS Vantage Manual De Instalación página 5

WALL SET INSTALLATION (Continued)
7. Dry Fit Back Panel
◘
Position back panel with tape.
◘
Trace back panel on wall.
◘
Remove panel.
IMPORTANT! For Allura, Alvea™, Enhance, Venture
and Vesuvia™ models install corner panels fi rst, then
back panels.
9. Install Corner Panels
APPLY ADHESIVE to corners using trowel, staying within
pencil lines.
APPLY SEALANT to back of corner panel as shown.
◘
Press and tape each panel to corner wall.
IMPORTANT! If using solvent-based adhesive, pull
panel away from wall for 30 seconds to allow solvents
to escape. Re-press panel fi rmly against wall.
IMPORTANT! The corner panels may overlap the side
and back panels.
8. Install Back Panels
APPLY ADHESIVE
◘
Press and tape panel against wall.
IMPORTANT!
panel away from wall for 30 seconds to allow solvents to
®
escape. Re-press panel fi rmly against wall.
10. Allow Adhesive to Dry
IMPORTANT!
adhesive dry time before removing tape.
5
to back wall using trowel.
If using solvent based adhesive, pull
Follow manufacturer's instructions for
B27778 Rev. B 5/9/16
Pencil
line