Labels - hager TX 450 Manual De Empleo

6
Configuration mode

6.1 Labels

This menu is used to indicate the function associated
with each touch pad.
The label may contain:
- text
- an icon
- text and an icon.
I
To add a label
• Select Add using the
touch pads.
• Press the touch pad
Select a label.
When all the labels have been assigned, it will be
necessary to Clear an existing label before a new
label can be added.
I
To select a label
Four labels are accessible (one for each touch pad on
the Room Controller).
The selected label appears in reverse colours (e.g.:
label 1 corresponds to the upper area of the screen).
• Select a label using the
touch pads.
• Press the
confirm.
The screen then displays a request
to enter the text and/or an icon.
• Press the
Enter text.
72
and
to access
and
touch pad to
touch pad to access
I
To enter text
This is done on a telephone type keypad. Each box includes
3 letters, 3 figures or a special function.
Navigation is done by using the
in accordance with the diagram above.
To enter a character:
• Select the corresponding box using the
touch pads.
• Press the touch pad rapidly once, twice or three
times until the desired character is displayed.
• Proceed in the same way for the following characters.
The purposes of the boxes below are as follows:
- ,.:;!? : displays punctuation characters
- ߣ... : displays special characters
- ±()[] : displays mathematical symbols
- AàÀ : displays upper case and accented characters
- clr : deletes the last character entered
- spc : inserts a space
- end : completion of text entry
- _ _ >
: displays the Icons table.
The number of characters available is limited. An error
beep indicates that the maximum number of characters
(which varies depending on the menu) has been reached.
73
and touch pads
and
hager