Setting The Frequency Mode; Reset Button; Display - Disney DDC9000-P Guia Del Usuario

SETTING THE FREQUENCY MODE

Because the electrical power frequency is either 50Hz or 60Hz,
depending on the country you are located in, please set it according
to the country that you are located in. If located in USA, set to 60Hz.
1
Turn the camera on as described
on page
Mode/Power button eight times to
select the Frequency mode; "60"
or "50" will appear in the display.

RESET BUTTON

1
To restore the camera to the
factory defaults, press
R E S E T button
compartment) using a pin or
similar item.
O P E R ATION (CONTINUED)
8. Press
(inside
2
Within 3 seconds, press the
the Shutter/Select button to select
the Frequency mode as shown
on the display i.e. if 60 appears,
press the Shutter/Select button
to change the setting to 60.

DISPLAY

The display can only display two
digits. Although the capacity for
pictures in Lo(w) Resolution is
100, the display will show 99 until
two pictures have been taken
and then change to 98.
RESET BUTTON NOTE: When
the
you press the RESET button, all
the taken photos in the camera
will be deleted.
13