Ingersoll Rand EL0410BC–SS–ESD Manual De Operación Y Mantenimiento página 3

FAILURE TO OBSERVE THE FOLLOWING WARNINGS COULD RESULT IN INJURY.
SPECIFIC SAFETY RULE
•
Hold tool by insulated gripping surfaces when
performing an operation where the cutting tool may
contact hidden wiring or its own cord. Contact with
a "live" wire will make exposed metal parts of the tool
"live" and shock the operator.
OPERATIONS CAUTIONS
•
Whenever changing a bit, make certain the
Forward/Reverse Switch is in the "OFF" position
and the tool is unplugged.
•
Do not allow chemicals such as acetone, benzene,
thinner, ketone, trichloroethylene or other similar
chemicals to come in contact with the screwdriver
housing as damage will result.
WARNING
Always wear eye protection
when operating or perform-
ing maintenance on this
tool.
WARNING
Powered tools can vibrate in
use. Vibration, repetitive mo-
tions or uncomfortable posi-
tions may be harmful to your
hands and arms. Stop using
any tool if discomfort, tingling
feeling or pain occurs. Seek
medical advice before resum-
ing use.
WARNING
DRY LOCATION USE ONLY.
GROUNDING INSTRUCTIONS
For safe use of adapters, the outlet box must be
grounded. If there is any doubt, have a qualified
electrician check connections.
WARNING LABEL IDENTIFICATION
Always wear hearing
protection when operating
this tool.
Do not carry the tool by
the cord.
Keep body stance balanced
and firm. Do not overreach
when operating this tool.
•
Do not drop or abuse the screwdriver.
•
Do not adjust the torque setting higher than 5 on
the Torque Scale.
Duty cycle:
MAX 0.5 sec. "ON"
MIN 3.5 sec. "OFF"
•
Do not tighten more than 900 tapping screws
(size: 2 mm, length: 4 mm) per hour.
•
Do not operate the Forward/Reverse Switch when
the motor is running.
•
Whenever a tool is not being used, move the
Forward/Reverse Switch to the "OFF" position and
turn off the Controller.
WARNING
WARNING
WARNING
EXTENSION CORDS
Make sure your extension cord is in good condition. When
using an extension cord, be sure to use one heavy enough to
carry the current your product will draw. An undersized
cord will cause a drop in line voltage resulting in loss of
power and overheating.
Use extension cord with 16 AWG (1.5 mm
100 ft. (30 m) in length maximum.
Replace damaged extension cords.
3
WARNING
Always turn off the electrical
supply and disconnect the
power cord before installing,
removing or adjusting any
accessory on this tool, or
before performing any
maintenance on this tool.
WARNING
Do not use damaged, frayed
or deteriorated power cords.
Alternating Current
V
Volts
W
Watt
A
Amperes
Ground
2
), up to