Front Panel - Apex Medical DOMUS AUTO 9P-077520 Manual De Instrucciones

English
English

2.3 Front panel

1. Pressure Adjust
The function can automatically adjust the mattress pressure based on the patient's weight. To
remind user the process is on-going, the function LED lights will be periodically flashed from left to
right until the Ready LED turn on permanently (the process is completed). There are three
conditions will trigger this function to ensure the appropriate pressure setting for the patient.
A) Press the Auto-Adjust button for 2 seconds, system will automatically re-adjust the
pressure setting.
B) The system will automatically start Auto-Adjust immediately after the initial mattress
inflation is completed.
C) While the system detects a significant change in patient's weight on the mattress (e.g.
patient Ingress) for a period of time, the system will automatically run the function again.
While the process is completed, system will return to previous setting automatically. To disable
this function, press Auto-Adjust button again.
2. TUNING
The Tuning function is to fine-tune the system auto-adjusted preset pressure. Three Tuning levels
are available. "0" is system auto-adjusted preset pressure. "+" is one level higher than preset
pressure, and "-" is one level lower than preset pressure.
3
NOTE: During the Auto-Adjust operation, it is normal that system will go through a
series of inflation and deflation.
NOTE: The Tuning function is only available in alternate and static mode.
1
5
4
5
2