Rigol DG1000Z Serie Manual De Uso página 169

Chapter 3 Remote Control
Remote Control via GPIB (Option)
1. Connect the device
Connect the generator to your computer using a USB to GPIB interface
converter (Option).
Note: please make sure that a GPIB card has been installed to your PC.
Connet the USB terminal of the USB to GPIB interface converter to the USB
Host interface at the front panel of the generator and the GPIB terminal of it
to the GPIB card terminal of the PC.
2. Install the driver of GPIB card
Install the driver of the GPIB card which has been connected to the PC
correctly.
3. Set the GPIB address
pulse Utility → I/O Config → GPIB to set the GPIB address of the
generator.
4. Search device resource
Start up the Ultra Sigma and click
figure (a). Click "Search" and the software will search the GPIB instrument
resources connected to the PC. The device resources found will be displayed
on the right side of the panel as shown in figure (b). Click "OK" to add the
resource.
DG1000Z User's Guide
to open the panel as shown in
RIGOL
3-9