Setup And Operating Procedures; Battery Loading; Clock And Date Adjustment - Joycare JC-1321 Manual Del Usuario

reception, which can be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the distance between the equipment and the receiver.
- Connect the device to an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
16. This blood pressure monitor is verified by auscultatory method. It is recommended that you check
annex B of ANSI/AAMI SP-10:2002+A1:2003+A2:2006 for details of verification method if you need.
NOTE: Do not forget: while self-measurement represents control, it does not constitute a proper
diagnosis or treatment. Any unusual values should always be discussed with your doctor.

SETUP AND OPERATING PROCEDURES

1. BATTERY LOADING

a. Open battery cover at the back of the monitor.
b. Load four batteries of the type "AA". Please pay attention to polarity.
c. Close the battery cover.
When the LCD shows the battery symbol , replace all batteries with new ones.
Rechargeable batteries are not suitable for this monitor.
Remove the batteries if the monitor will not be used for a month or more to avoid relevant damage of
battery leakage.
Do not let battery fluid get into your eyes. If it should get in your eyes, immediately rinse with plenty
of clean water and contact a physician.
The monitor, the batteries and the cuff, must be disposed of according to local regulations at
the end of their usage.

2. CLOCK AND DATE ADJUSTMENT

a. Once you install the battery or turn off the monitor, it will enter Clock Mode, and LCD will display time
and date by turns. See Fig. 2 and 2-1.
2 2.1 2.2
b. While the monitor is in Clock Mode, pressing the "START" button and the "MEM" button simultaneously;
a beep is heard and the month will flash first. See Fig. 2-2. Press the button "START" repeatedly; the
day, the hour and the minute will flash in turn. While a number is flashing, press the button "MEM" to
increase the number. Hold the button "MEM" depressed, the number will increase rapidly.
c. You can turn off the monitor by pressing the "START" button when the minutes are flashing, then the
time and the date are confirmed.
d. The monitor will turn off automatically after 1 minute of no operation; with the time and date
unchanged.
e. After replacing the batteries, you should set the time and the date again.
14