Drinkwell PWW17-16560 Guia De Inicio Rapido página 9

13. Attach the lid to the tower. Pick up the pet fountain
by the bowl and place it in a desired location.
Pour water into the bowl, leaving 13 mm of space
between the water level and the rim of the bowl.
14. Make sure the electrical power cord, the power
adaptor and your hands are completely dry.
Connect the in-line plug and make sure no silver
is showing, then plug the adaptor into a mains
power outlet.
NOTE: Never let the water level fall below 2.5 cm from the base of the bowl or your pump
might fail.
Pet Fountain Cleaning
NOTE: Replace the charcoal filter every 2-4 weeks and replace the foam filter every 1-2 months.
1. Unplug the pet fountain, and disconnect the in-line plug.
2. Pick up the pet fountain by the bowl, and take it to the sink.
3. Pour out the water, and then disassemble the pet fountain.
4. Discard the charcoal filter and the foam filter. Clean the pump (see Pump Cleaning section for instructions).
Use a solution of 80% water and 20% white vinegar to remove hard water buildup.
5. Wash all other parts with warm water and soap, or place in the top rack of the dishwasher.
NOTE: Do not place the adaptor, rubber connector or pump in the dishwasher.
13
14
petsafe.com
9