STOK Island SGP2120N Manual Del Operador página 11

STEP 4: INSTALLING LEFT SIDE BRACE AND
CASTERS
See Figure 8.
Remove the following hardware from the blister pack:
KK - Caster tool
Set the left side brace onto each of the leg sections,
aligning the holes on each side of the brace with holes
in leg sections.
Thread the casters into holes on the left leg assembly.
Tighten casters, as shown, with caster tool (KK).
Lock caster wheels.
CASTER
CASTER
TOOL (KK)
Fig. 8
STEP 5: INSTALLING WHEELS
See Figure 9.
Remove the following hardware from the blister pack:
II
- Cotter pins and washers
Slide axle all the way through axle hole in right leg brace,
so that axle appears out of both ends.
On each side of axle, slide on a wheel, then the flat washer
and secure with cotter pin (II), as shown.
RIGHT LEG
WHEEL
AXLE
Fig. 9
HOLES
LEFT LEG
SECTION
LEFT SIDE
BRACE
COTTER
PIN AND WASHER
(II)
BRACE
ASSEMBLY
STEP 6: ASSEMBLING THE PREP TABLE TO
THE FIREBOX
See Figure 10.
Remove the following hardware from the blister pack:
AA - 4 Screws (M5 x 12 mm)
BB - 4 Flat washers (M5)
CC - 4 Lock washers (M5)
Set the firebox upside down on a flat surface.
Slide the prep table into the tubes on the sides of the
firebox.
Align the holes in the right and left side brackets with the
holes in the firebox tube.
Slide a lock washer (CC) and flat washer (BB) over each
screw (AA).
Insert screws (AA) into the holes in the firebox tubes and
tighten securely.
PREP
TABLE
BRACKETS
FIREBOX
Fig. 10
11
LOCK
WASHER
(CC)
SCREW
(AA)
TUBE
FLAT
WASHER
(BB)
FIREBOX
TUBE