Other Symbols; Installation; Setting Up Light Source - Cuda surgical HLS-150 Manual Del Operador

4.3 OTHER SYMBOLS

ON (Power connected to Mains)
OFF (Power disconnected from Mains)
AC Current
Protective Earthing
Equipotentiality
Type BF Applied Part
Attention – Consult Accompanying
Documents.
Do not dispose of in ordinary municipal
waste, Recycle.

5.0 INSTALLATION

5.1 SETTING UP THE LIGHT SOURCE
Place the light source on a stable surface (cart, counter, stand, etc.).
NOTE Avoid places where the light source may be splashed with
liquid.
Absolutely DO NOT use in any environment with explosive or flammable
gases.
DO NOT block the venting grids of the light source.
Make sure the power switch is in OFF position.
Connect AC power cord to the power inlet located on the rear panel of the light source.
CAUTION Use only cords provided with the light source.
Plug the AC power cord into a wall outlet using the three (3) prong plug supplied with the
unit.
®
LIT091 CUDA SURGICAL
(English)
I
O
Page 8 of 60
1 2
3 4
Rev. G