Connecting Light Cable; Operation; Powering Up Light Source; Light Brightness Control - Cuda surgical HLS-150 Manual Del Operador

CAUTION To prevent electric shock, connect power cords of peripheral
equipment through medical isolation transformers.
NOTE When using medical isolation transformer, be sure to check the
transformer power ratings.
Make sure that the power cord is connected to the main power
with three prong plug (USA use UL2601-1 rated isolation
transformers and/or power strips only).
5.2 CONNECTING THE LIGHT CABLE
Connect the light cable to endoscope and then plug the light cable endfitting into the
appropriate port of the turret on the front panel.

6. OPERATION

6.1 POWERING UP THE LIGHT SOURCE
To operate the light source: Attach the light source to the instrument or headlamp.
Turn on the power switch. The fan will start.
6.2

LIGHT BRIGHTNESS CONTROL

The light brightness adjustment enables the user to obtain a brighter or darker
illumination of the object of observation.
Adjust the light intensity by turning the intensity control knob.

7. CLEANING

NOTE Always disconnect the power cord before cleaning the system
The control unit can be cleaned with any cleaning agents, used for external cleaning of
electric equipment, according to instructions given by the manufacturer of the cleaning
solution.
Do not allow excessive moisture or liquids to come in direct contact with the control unit.
Do not use cleaning agents that are not permitted for use with plastics, i.e., ammonia,
acetone, salty acids (HCl), etc.
Do not allow cleaning agents or liquids to enter the control unit outlets.
®
LIT091 CUDA SURGICAL
(English)
Rev. G
Page 9 of 60